# Pipe Fitting - Simple and Rolling Offsets - Course No. 10

How to calculate and fabricate offsets using screwed, flanged and welding fittings.
Manufacturer:
\$52.00

Course No. 10

20 hours

Pipe Fitting – Simple and Rolling Offsets

Section A (6 hours) : Use of the “invisible box” method of showing simple offset dimensions on isometric single-line piping drawings. Standard pipe fitting handbook tables to find the set, run, and travel measurements for the common offset fitting angles. Calculation of cut lengths of pipe to make simple offsets using screwed, flanged, and welding fittings. Section B (9 hours) : Use of the “invisible box” method of showing rolling offset dimensions on single-line piping drawings. Pipe fitting handbook tables  and the “steel square” to calculate and lay out the set, run, roll, and travel measurements using the common angular fittings. Calculation of cut lengths of pipe to make common rolling offsets from screwed, flanged, and welding fittings. Section C (5 hours) : Several practice problems using two-pipe equal-spread offsets and offsets around  common field obstructions. Simple pipe fitting handbook  formulas are used in the solution of practical field problems using simple offsets.

Prerequisites: The ability to use whole numbers, fractions, and decimals, read simple single line piping drawings, and use pipefitting  handbook  tables.

View Format

Customers who bought this item also bought

## Pipe Fitting - Measurement and Layout - Course No. 9

Interpretation of piping drawings, calculation of cut lengths for threaded pipe & calculation of cut lengths for welding.
\$52.00

## Pipe Fitting- Pipe and Fitting Identification -Course No. 8

Identification of common wrought iron pipe and identification and selection of pipe fittings.
\$45.00

## Gear and Gearing – Gear Installation - Course No. 66

Gear installation, removal, handling and maintenance.
\$29.00

## Pipe Fitting – Layout Practices - Course No. 64

Covers how to locate and mark pipe and fitting center lines.
\$28.50